Stains on glass: how to remove them and prevent them from returning

Almost all stains on glass can be removed with little effort: clean water, a squeegee with a good rubber blade, or a microfiber cloth, and the right moment to dry. In most cases, the issue lies with the method, not the dirt. A film remains because the product dried too quickly, the wrong cloth was used, or wet dust was spread across the glass. Below, we explain how to identify the type of stain you are facing, which method performed best in tests, how to handle difficult cases like limescale or construction debris, and what to do to keep the glass clean for longer.
In summary
- Always start by dusting with a damp cloth. Only then apply the cleaning solution.
- In DECO PROteste tests, the methods that removed stains best were newspaper with water and squeegee with water, outperforming multi-purpose products and vinegar.
- Stop drying when the glass still has a fine and even layer of moisture: it evaporates on its own without leaving marks.
- Remove cement, mortar, or plaster residues as soon as you see them, always using gentle means, as they are very alkaline and can damage the glass.
- Work in the shade and on a day without strong winds, and set aside kitchen paper and cotton cloths.
Index
- What type of stain is on the glass
- The method that leaves glass streak-free
- What tests say about products and methods
- Limescale and water spots: the case of the shower and windows
- Construction debris: cement, mortar, and paint
- Frosted and satin glass without damage
- The right tools
- How to prevent stains from returning
- Our experience with glass in Lisbon
- When it makes sense to call a professional team
- Frequently asked questions
- Sources
What type of stain is on the glass
Before grabbing a product, take a good look at the stain. Each type has a different cause and requires a different solution. Use the table as a quick guide:
| Stain | Most likely cause | How to recognize it | What to do |
|---|---|---|---|
| Streaks and films after cleaning | Product dried on the glass, cloth that sheds fibers, direct sunlight | Appear when the glass dries, more visible against the light | Clean again in the shade, with a squeegee or microfiber, and dry at the right moment |
| Water spots | Rain, watering, splashes that dry with dust | Dull circles or drops, especially on the outside | Wet thoroughly, let soften, and use the squeegee |
| Limescale | Minerals from water that remain when it evaporates | White and rough film, typical in shower enclosures | Regular cleaning and drying after each use |
| Grease and fingerprints | Hands, kitchen, children, pets | Oily marks that spread when rubbed | Water with a bit of detergent and rinsing |
| Construction debris | Cement, plaster, mortar, paint | Hard and raised spots, sometimes gray or white | Remove immediately, with gentle means and plenty of water |
| Salt and dust from outside | Sea spray, traffic, street works | Grayish and uniform film on the outside | Wash first with plenty of water and only then clean |
If the stain does not come off with any of these steps and feels like a mark within the glass itself, it may be a defect or surface corrosion and not dirt. In that case, do not insist with scrubbing pads or blades: talk to the person who installed or supplied the glass.
The method that leaves glass streak-free
When the glass looks "worse after cleaning," it almost always means one of these steps was missed. Follow them in this order:
- Choose the right time. Clean when that part of the house is in the shade and the wind is light. This way, you finish before the product dries on the glass, as recommended in a guide on cleaning glass and mirrors without streaks. For south or west-facing facades, this may mean cleaning early in the morning.
- Dust first. DECO PROteste advises starting with a damp cloth to remove dust and only then apply the chosen solution. If you spray a product directly onto the dust, you end up with a fine mud spread across the glass.
- Wet the glass well. Use the sponge of the squeegee or a microfiber cloth soaked in clean water. For stubborn stains, let the water act for a minute to soften the dirt.
- Use the squeegee in strips. Go from top to bottom or in an "S" shape, always applying the same pressure, and wipe the rubber with a dry cloth between passes.
- Dry at the right moment. This detail separates clean glass from shiny glass. A technical bulletin from Pilkington on manual washing of glass recommends stopping drying when the glass is almost dry and still has a fine and even layer of moisture. This layer evaporates quickly and leaves the surface clean. Those who continue to scrub until the end end up dragging fibers and residues.
- Finish at the corners and frames. Wipe a dry microfiber cloth along the edges where the squeegee cannot reach and on the frames, so that dirty water does not run back onto the glass.
In homes that are very exposed to the sun, cleaning is more difficult in summer, and dirt becomes more visible. If you are considering solar protection for these windows, check out these ideas for shading south-facing windows: they protect the house from heat and allow you to work on the glass without rushing.
What tests say about products and methods
DECO PROteste tested various ways to clean glass in 2025. The results contradict some tricks that are passed from home to home. In the DECO PROteste cleaning effectiveness assessment, these were the ratings:
| Method or product | DECO PROteste rating (2025) | Best for |
|---|---|---|
| Newspaper + water | 4.4 (stain removal) | Streak-free finish |
| Squeegee + water | 4.3 (stain removal) | Large glass, windows, and sliding doors |
| Specific glass wipes | 3.9 (cleaning effectiveness) | Quick touch-ups and mirrors |
| Glass cleaner spray | 3.8 (cleaning effectiveness) | Fingerprints and light grease |
| All-purpose detergent | 2.2 (cleaning effectiveness) | Not recommended for glass |
| Multi-purpose vinegar | 2.2 (cleaning effectiveness) | Not recommended for glass |
The conclusion is simple: for everyday use, water and technique are worth more than the bottle. The spray or wipes help when there is grease, such as on kitchen glass doors or bathroom mirrors, but they do not replace a good squeegee.
Vinegar on glass: when it makes sense
Vinegar is the most cited home trick, but in tests, multi-purpose vinegar lagged far behind water with a squeegee or newspaper. If you still want to use it, always dilute it in water and protect stone sills beforehand. Marble and limestone, so common in Portuguese windows, do not tolerate acids well and can lose their shine. Rinse the glass with clean water at the end, to avoid any smell or residue.
Limescale and water spots: the case of the shower and windows
In Lisbon, the tap water is not among the hardest. According to EPAL, the hardness of the water distributed in Lisbon varies between 40 and 170 mg/l of calcium carbonate, with an average of 80 mg/l. Even so, where water evaporates daily, like in the shower enclosure, minerals accumulate to form that white film.
For shower glass, what works is routine, not force:
- In daily use, use neutral detergent and a soft material, rinse, and dry at the end, as indicated in the glass and mirror cleaning guide. A small squeegee hanging in the shower makes this step a matter of seconds.
- When limescale is already installed, do several gentle cleanings in succession instead of scrubbing with abrasives. Green scrubbing pads and abrasive powders scratch the glass, and the scratches accumulate dirt even faster.
- In areas with metal profiles or silicone joints, rinse well so that no product remains on the parts.
On exterior windows, the spots you see after rain are mostly dust and pollution that the water has gathered and left behind as it dries. In neighborhoods near the river or the sea, salt also accumulates. Here, the most important step is the second one in the method: wet and rinse well before using the squeegee, to avoid rubbing grains of sand against the glass.
The sliding glass doors of balconies and verandas require the same care, with more attention to the tracks, where sand accumulates and dirties the glass every time the door opens. To care for them in the long term, see these tips on maintenance of sliding glass doors, and in our guide, we explain how to clean window tracks without damaging them.
Construction debris: cement, mortar, and paint
After renovations or painting, glass often ends up with spots of mortar, splashes of plaster, or paint marks. Here, haste helps. The cleaning recommendations from the glass manufacturer Glas Marte state that residues of concrete, cement, plaster, and mortar should be removed immediately and with non-aggressive means, as they are very alkaline and can damage the glass.
In practice:
- Wet the residue well with plenty of water and let it soften.
- Remove it with a soft cloth or sponge, without scrubbing dry. A grain of sand dragged across the glass scratches it forever.
- Do not use metal scrubbing pads or abrasive products.
- If the glass has special coatings (solar control, low emissivity, self-cleaning), confirm with the supplier which products and tools you can use before cleaning.
If you have just renovated your home, our guide on post-painting cleaning shows the right order to get your home ready to live in, including the glass.
Frosted and satin glass without damage
Frosted, sandblasted, or satin glass has a porous surface that attracts grease and fingerprints and marks easily. The instructions from Glas Marte for satin glass recommend always cleaning the entire surface, with a silicone-free and acid-free product, using soft cloths, chamois, or soft sponges and without scrubbing hard.
The detail of cleaning the entire surface matters a lot. If you only clean the area of the stain, a "halo" will remain around it, which is more noticeable than the original stain. On interior doors and frosted enclosures, always clean from one side to the other and rinse with clean water.
The right tools
You don’t need much, but you need the right materials. DECO PROteste suggests specific wipes or glass cleaner sprays for cleaning, and for finishing, a squeegee with a sponge on one side and rubber on the other, a microfiber cloth, or newspaper. It advises against cotton cloths and kitchen paper, which shed fibers and leave streaks.
The kit we recommend for home:
- Squeegee with a sponge on one side and rubber on the other. Replace the rubber when it has cuts or becomes hard, as worn rubber leaves water streaks.
- Two or three microfiber cloths: one for dusting, another for finishing, and another for the frames. Wash them without fabric softener, which removes their absorbency.
- Bucket with clean water, changed whenever it becomes cloudy.
- Glass cleaner spray for grease and fingerprints in the kitchen and on mirrors.
- Extension pole, if you have high windows or skylights. Never lean out of the window: for exterior glass that you cannot safely reach, call someone who works with the appropriate equipment.
The frames deserve special attention, as each material reacts differently. Our guide on cleaning frames explains the method for aluminum, PVC, and wood.
How to prevent stains from returning
Well-cleaned glass stays beautiful for longer. These habits make a difference:
- Rinse before cleaning exterior glass, especially after windy days, dusty rain, or street works.
- Clean the frames and tracks in the same session. If they get dirty, the first rain will wash that dirt onto the glass.
- Dry the shower enclosure after each shower. It takes less than a minute and prevents limescale.
- Maintain a regular rhythm. Frequent small cleanings are less tiring than a big clean after months. To fit the glass into the rest of the house, see our house cleaning calendar.
- Protect stone sills from acidic products and always rinse them at the end.
For interior glass, such as partitions, doors, and mirrors, our guide on cleaning interior windows shows how to organize the work room by room.
Our experience with glass in Lisbon
In the homes where we work in Lisbon, stains on glass are rarely a product problem. They are a method and routine problem. We find enclosures with months of limescale, windows facing the river with a veil of salt and dust, and new glass with spots of mortar left from construction. In all cases, the solution is the same sequence: dust, wet well, use the squeegee, dry at the right moment, and finish at the frames.
That’s why we work with detailed checklists, so that the glass always meets the same standard, regardless of which professional comes to your home. Whenever possible, we keep the same team, who already know your windows, your stone sills, and the areas that require more care. After each visit, you receive a digital report, and if anything is not as you expected, we resolve it quickly.
For those with a holiday home or a property between tenants, the glass makes a big difference in the first impression. A house can be immaculate, but if the windows have spots and streaks, that’s what you see first.
Flaws
When it makes sense to call a professional team
If your home has many windows, high ones, or is full of construction debris, or if you simply prefer to spend the weekend on something else, Cleaning Point will take care of it for you in Lisbon. Window cleaning is one of the extras you can add to regular cleaning or a deep clean, done by selected and trained professionals, with a clear checklist and support in multiple languages.

Are you moving house, handing over an apartment, or preparing a holiday home for the next guests? Our move-in and move-out cleaning and post-renovation cleaning services include the attention to glass that these moments require. Check out the available extras, including window cleaning, or book your cleaning now.
Frequently asked questions
How to clean dull glass?
Start by dusting with a damp cloth and then wet the glass well with clean water. Use the squeegee in strips and stop drying when there is still a fine and even layer of moisture, which evaporates on its own. If the glass remains dull, it may be limescale or an old residue: repeat the gentle cleaning instead of using abrasives.
Why does the glass look worse after cleaning?
Almost always because the product dried too quickly, due to the sun or wind, or because kitchen paper or cotton cloth was used, which leave fibers. Another common cause is cleaning without dusting first, which spreads wet dirt. Clean in the shade, with microfiber or squeegee, and change the water as soon as it becomes cloudy.
How to clean frosted glass?
Always clean the entire surface, with a silicone-free and acid-free product, and use soft cloths, chamois, or soft sponges. Do not scrub hard or only clean the area of the stain, to avoid leaving a halo. Rinse with clean water at the end.
How to make glass shine?
In DECO PROteste tests, the best results came from simple methods: newspaper with water and squeegee with water. The shine comes mainly from technique: good squeegee rubber, clean microfiber cloths, and drying at the right moment. Always finish at the corners and frames.
How often should I clean the windows?
It depends on the exposure of the house. Windows facing busy streets, construction sites, or near the river get dirty faster than interior ones. The most practical approach is to include glass in a regular routine and immediately clean residues that can damage the glass, such as construction debris.
Sources
DECO PROteste: How to clean glass and windows without streaks
Pilkington: Technical Bulletin ATS-144, Manual Washing of Clear and Tinted Glass
Glas Marte: Cleaning and Care Instructions
[CNN Brasil: Glass and mirrors, how to clean and dry without leaving streaks](https://www.cnnbrasil.com.br/comportamento/casa-e-decoracao/vidros-e-espelhos-como-limpar-e-secar-sem-deixar-marcas/


